Instructions

How to do stuff
8 articles

Tulip Blinds Online Ordering Instructions

20.09 Bespoke spool cord attaching instructions

When receiving the 20.09 Roman Headrail Kits the spool cord will be situated in the tubing. The cords are in small bags with 3.5m of cord in each. The end of the cord is sticking out of the bag ready to double knot at the end of the cord. Then slide cord knot into the grove on the spool,pull tight, ...

20.02 Assembly Instructions

Is the cord lock on the correct side?If you need to swap sides, you loosen the screw that holds the cord lock in place and slides over to the opposite side, and retighten the screw. You will also need to take out the cord guides. How do I position the Cord Guides?This is done by twisting the cord gu...

20.09 Bespoke & 20.04 Roman Headrail Kits, Fitting Instructions, including how to fit chain breaker

Firstly fit the breackets ( 3 choices here, swivel, spring and top fix), the swivel and spring can be either top fix or face fix, the top fix is only top fix ( to ceiling for example)Decide what fixings you are going to use depending on the application. It is very important to choose the correct fix...

Changing Direct Drives on A Tulip Roman Headrail​

All Tulip Roman Headrail drive units can be changed quite easily. Just loosen three screws and slide out the drive unit. Remove the other end cap and place in the other end of the track. Place the drive unit it in the other end of the track, you may have to loosen the spool click down to allow the d...

Changing from Roman Headrail Direct Drive to a PullAway Drive

How to amend Headrail to take a Pull Away Drive supplied with a Direct Drive1. Loosen screws that are holding the drive in the headrail.2. Loosen the screw that is holding the drive bar in the drive. 3. Slide drive out of headrail 4. Reduce the width of headrail by 3mm 5. Reduce the width of drive sha...

Zebra Fitting Video

Wiring 12v Transformer

There are two options with hard wiring motors-single blind transformer and a four blind transformer. The singe blind transformer, is as you would expect, used for one blind. It joins into the 2 core motor cable and then plugs strait into a 13amp socket. It's self contained. I deal for one blind where...